Compatible with MG5000, MG5050, Spectra SP V3.00 (or later) and RTX3 V1.31 (or higher).
Supports operation StayD.
Memory system status: The REM3 will keep the last state of the system will take the memory. Momentary press the Info button to see the status of the system even if you are out of his reach.
Adjusting for what subsystem REM3 will arm or disarm.
Built-in transceiver (433MHz or 868MHz).
|Compatible with MG5000, MG5050, MG6250, and Spectra SP series V3.00 (or higher) and RTX3 V1.31 (or higher)|
|System Status Memory: The REM3 will keep the last system status received from the control panel in memory. Momentarily press the Info button to display the last system status--even when out of range. Used to confirm the last action you did on the system while away from the system.|
|Configure which partitions the REM3 arms/disarms|
|Built-In Transceiver (433MHz or 868MHz)|
|Independent Arm, Sleep, Stay and Off buttons and LED display per partition|
|Control up to 6 PGMs and/or generate panics|
|Keypad Mode: Requires code entry|
Remote Mode: One-touch arming / Disarming
|Installer Diagnostic Mode:|
Partition 1 LEDs = Signal Strength Display
Partition 2 LEDs = RF Interference Display
|Provides visual and auditory feedback of system status|
|Press the Status button to receive system status|
|Label to identify remote control owner|
|Compact, water-resistant design|
|Size: 8cm x 3.4cm x 1.5cm (3.1in x 1.3in x 0.6in)|